1. 開關順序 Switching sequence
1) 顯示屏開關順序:
開屏時:先開機,后開屏;關屏時:先關屏,后關機。
2) 開關LED顯示屏,間隔時間要大于1分鐘。
1) Screen switching sequence;
ON:first ture on the computer,then screen
2) Interval of switching LED display must be greater than 1 minute.
2. 環境溫度 Ambient temperature
環境溫度過高或散熱條件不好時,應注意不要長時間開屏,屏幕應安裝在-10℃~40℃溫度范圍環境,超出溫度范圍時需加裝溫控設備。嚴禁在任何發熱源附近進行創銳特的LED顯示屏安裝工作.
When ambient temperature is too high or cooling condition is bad, users had better not to turn on the screen for a long time. Screen shall be installed in temperature from -10℃~40℃, over environment temperature range,temperature control equipment must be installed. it is forbidden to install LED display near any heat source.
3. 環境濕度 Ambient humidity
安裝顯示屏時,環境相對濕度應在30%~70%范圍,當室內環境濕度低于30%時容易產生靜電;當室內環境濕度高于70%時容易導致電子器件受潮.
When installing screen,ambient relative humidity should be in the range from 30% to 70%, it is prone to get static electricity when the indoor humidity is below 30%;when the indoor humidity is higher than 70%,electronic components are easy to get damp.
4. 腐蝕性氣體環境 Corrosive gas environment
請不要將顯示屏安裝在含有酸或堿成分等腐蝕氣體環境中,如化學藥品倉庫附近.
Please do not install the display in corrosive gas environment containing acid or base components, such as chemical warehouse.
5. 電磁輻射環境 Electromagnetic radiation environment
請不要將顯示屏安裝在電磁輻射、射頻輻射超過場強5V/m干擾源的環境中,如有需要必須做隔離處理.
Please do not install the display when electromagnetic radiation environent is over field strength 5v/m. if necessary, isolationtreatment should be taken.
6. 保持電源穩定 Steady power supply
保持供電電源穩定必要時在配電箱內加裝浪涌開關,并做好接地保護避免雷擊,在強雷電天氣及其他惡劣的自然條件下不要使用顯示屏.
If necessary, users have to install surge switches in the distribution box and ground fault protection to avoid lightning strikes, Do not use the display in strong lightning and other severe weather.
7. 嚴禁屏體接觸水,金屬粉塵等易導電的物質
Conductive material is strictly prohibited to contact display, such as metal dust and water.
顯示屏盡量放置在低灰塵的 環境中,否則會對顯示效果造成影響,同時會對電路造成損害。如果因為各種原因接觸到水,請立即斷電直至屏體單元板干燥后方可使用.
Screens are placed in the environment of lowdust as far as possible, otherwise it will affect the display effects, as well as damage the circuit, if exposed to water for various reasons, please immediately power down until the screen unit dry.
8. 控制色彩顯示 Controlling colors.
不要使顯示屏長時間處于全白色、全紅色、全綠色、全藍色等全亮畫面,因為這樣會影響顯示屏使用壽命.
Do not display a long time in a white,red,green,blue or other bright screen, because this will affect the display lifetime.
9. 控制使用時間 Controlling time.
LED顯示屏大屏幕每天至少休息2小時;一般每星期至少開啟CTS系列創銳特屏幕兩次以上(特別是梅雨季節時需要每天開啟一次)且點亮時間需要2小時以上.
LED display at least rest 2hours a day,Normally turn on the screen at least twice a week or more (Especially in the rainy season it is necessary to turn on the display every day), and it maintains more than 2 hours every time.
10. 定期全面檢修 Regular overhaul.
LED顯示屏需要定期檢查,線路有無損壞,如不工作要及時更換線路,有損壞時要及時修補或者更換.
LED display requires regular inspection to check circuit damage, if it does not work, change it in time, if circuit damages, it should be repaired or replaced.
11. 安全警示 Security alerts
LED顯示屏在安裝時,要確保安全,工廠僅提供產品好框架固定參考方案,相關安全方面用戶需結合當?shù)厍闆r和現場條件,提請有關方面論證好確認.
Users must ensure safety while installing led display, the factory only offers products and reference programs of frame fixation, users can ask relevant authorities to confirm according to local conditions and field conditions.
專業、誠信、謙恭、熱情 聯系18010136668穆經理,免費獲取專業方案和預算評估!
車載透明屏創意顯示LED透明屏異形透明屏玻璃屏貼膜屏2023年02月15日
櫥窗透明屏幕墻透明屏LED透明屏LED顯示屏2022年10月19日
櫥窗透明屏幕墻透明屏LED透明屏LED顯示屏2022年09月28日
櫥窗透明屏幕墻透明屏LED透明屏LED顯示屏2022年07月26日
車載透明屏創意顯示LED透明屏異形透明屏玻璃屏貼膜屏2022年05月13日
室內顯示屏LED顯示屏廣告顯示屏2022年04月20日
櫥窗透明屏幕墻透明屏LED透明屏LED顯示屏2022年04月17日
2022年07月26日
創意顯示2022年04月20日